RevEng Schematic Learner
Brand: ABI Electronics
Product Code: RevEng System
Mejdaf part number 622-99
Availability: Out Of Stock
OverviewThe learning process is achieved through clips, connectors and probes that are attached to clusters of components. RevWin guides the operator to place and walk the clips around the reference circuit. RevWin generates the most efficient sequence of clip combinations and movements to learn all possible connections. However, the operator can modify and override the automatic placement of the clips if necessary. To minimise operator errors, the system applies an orientation check and pin check to confirm clip contact and position. RevEng learns without applying power to the board and limits the applied voltage and current so that semiconductor gates are not affected - it is also safe to use on low power technologies. There is a wide range of IC clips and connectors. If a clip or connector is not available or cannot be fitted due to the physical constraints of the board then the hand held probe and buzzer facilities are used.
Software packages A professional drawing capability is provided by EdWin from Visionics. Important facilities include:
Optional facilities include Bill of Materials, PCB Layout, Mix-mode simulation, Arizona Autorouter, Thermal Analyser, EDSpice, EMC + Signal Integrity Edwin provides special features to enable drawings to be generated in less than a day.
SYSTEM 8 Ultimate controls the hardware and provides links with the CAD software. Key features include
|
 |
Cabinet Systems High pin count system for multiple requirements and large circuits.
Cabinet equipped with control card and 1024 to 2048 channel measurement channels
Systems can be expanded to 2048 channels at any time after installation to meet changes in budget availability or application requirements. |
Presentations
 |
View the prezi presentation of RevEng ABI Schematic Generation - click here |
