Fluke i310s Current Probe
3,063.60SAR
3,063.60SAR
Ex Tax: 2,664.00SAR
The i310s current probe is based on Hall Effect technology for use in measurement of both DC and AC current. The i310s may be used in conjunction with oscilloscopes and other suitable recording instruments for accurate non-intrusive current measurement.
Electrical Characteristics Current ranges 30 A and 300 A AC rms or ±45 A and 450 A DC Measuring ranges ±45 A and 450 A DC AC rms or DC ±45 A and 450 A Inrush current 600A AC rms MAX Output sensitivity 10 mV/A (30 A) 1 mV/A (300 A) Accuracy (at +23°C) (30 A range) ±1% of reading ±50 mA (300 A range) ±1% of reading ±300 mA Bandwidth to meet accuracy specification 1 kHz Phase shift below 1 kHz < 2 degrees Resolution ±50 mA (30 A) ±100 mA (300 A) Load impedance > 10 k Ohms and ≤100 pF Conductor position sensitivity ±1.5% relative to centre reading Frequency range (small signal) DC to 20 kHz (-3 dB) Phase shift below 1 kHz < 2° Temperature coefficient ±0.1% of reading / °C Power supply 9 V Alkaline, MN1604/PP3 Battery life 30 Hours, low battery indicator Working voltage (see Safety Standards section) 300 V AC rms or DC General Characteristics Maximum conductor size 19 mm diameter Output connection Safety BNC connector Supplied with safety 4mm adaptor Output zero Manual adjust via thumbwheel Cable length 2 metres Operating temperature range -10 to +50°C Storage temperature range (with battery removed) -20 to +85°C Operating humidity 15% to 85% (non-condensing) Weight 250 g Safety Standards BS EN 61010-1 2001 BS EN 61010-2-032 2002 BS EN 61010-031 2002 300 Vrms, Category III, Pollution Degree 2 EMC standards BS EN 612361998 +A1, A2, and A3 Use of the probe on un-insulated conductors is limited to 300 V AC rms or DC and frequencies below 1 kHz