Fluke i30 AC/DC Current Clamp
36,046.75SAR
36,046.75SAR
Ex Tax: 31,345.00SAR
The i30 current clamp is based on Hall Effect technology for use in measurement of both DC and AC current. The i30 may be used in conjunction with multimeters, recorders and other suitable recording instruments for accurate non-intrusive current measurement.
Electrical Specifications Specified current range 30 mA to 30 A DC, 30 mA to 20 A AC rms Usable current range 5 mA to 30 A DC, 30 mA to 20 A AC rms Crest Factor 1.4 in Output sensitivity 100 mV/A Accuracy (at +25°C) ±1% of reading ±2 mA Resolution ±1 mA Load impedance > 10 k Ohms and ≤ 100pF Conductor position sensitivity ±1% relative to center reading Frequency range DC to 20 kHz (-0.5 dB) Temperature coefficient ±0.01% of reading/°C Power supply 9 V Alkaline, MN1604/PP3, 30 hours, low battery indicator Working voltage (see Safety Standards section) 300 V AC rms or DC General Specifications Maximum conductor size 19 mm diameter Output connection 4 mm safety connector Output zero Manual adjust via thumbwheel Cable length 1.5 meters Operating temperature range 0°C to +50°C Storage temperature range (with battery removed) -20°C to +85°C Operating humidity 15% to 85% (non-condensing) Weight 250 g Safety standards BS EN 61010-1:2001 BS EN 61010-2-032:2002 BS EN 61010-031:2002 300 V rms, Category III, Pollution Degree 2 Use of the probe on uninsulated conductors is limited to 300 V AC rms or DC and frequencies below 1 kHz EMC Standards EN 61326: 1998 +A1, A2, and A3